Clean Dangles Tool

Clean Dangles Tool

Target layer: Polyline

Description: Drag a selection box. All the selected polylines will be intersected with each other ( regular nodes will be created everywhere two polylines intersect). The dangling parts of the polylines entirely within the selection box and with length less than specified dangling tolerance will be removed.

Advantages:

multiple dangles removed with a single selection

Hot Keys (Pressing these keys when the tool is active will allow changing the parameters used by the function):

"S" - allows adjusting the Fuzzy Tolerance
"A" - Adjust the dangling tolerance. Only the dangle polylines shorter than this tolerance will be deleted. If set to 0 all polylines within the selection box will be deleted.

Attribute Updates: The attributes will be updated according to the attribute update rules defined for the target layer. (see Setting Attribute Update Rules for more information)

Note: Switch ON the Draw Nodes tool to visualize the status of the node topology.

Before

Result