A. Single Use license

The registration process involves three steps

1. Visit ET GeoTools page on ShareIt.com and order the program. You will receive a reference number for your order.
2. Click button to open ET GeoTools control panel ==>  select the About Tab. - click Request License Key button. Fill the   small form - all the fields are required.
   • User Name
   • Company
   • ShareIt reference number ( see Step 1)

   After filling the form there are two options to chose from:

   • Create Key Request File will write all the information to a file (*.et2). Send this file to register@ian-ko.com and in 24 hours you will receive the Key File that will unlock the full version
   • Send Key Request via e-mail. This option will open you default e-mail program with all necessary information. You just have to click the SEND button

   Important note:

   Do not change anything in the request file or the body of the generated message. It will cause the registration process to fail.

3. When you receive the Key File , save the attachment (*.ett file) to you hard disk. Click on Register button (ET GeoTools control panel ==> About Tab). In the form, click on Load Key File button. Select the received file. The ET GeoTools control panel will close. The program will be registered.

Important note:

Do not change anything in the Key File. It will cause the registration process to fail.

B. Concurrent license

ET LicenseManager should be installed on a PC on your network

1. Contact your system administrator and get the following information:
   • The Name or IP address of the PC where the ET LicenseManager is installed
   •   The TCP port on which the ET License Manager communicates
2. Click on the button to open ET GeoTools control panel.
3. Click on the About Tab
4. Click on the Connect To License Server button
5. In the dialog fill
   • License Server - fill the network name or the IP Address of the license server
   • TCP Port - fill the port number
6. Click on the Test License Server button
7. If a connection to the license server is established, click OK to save the settings. You are ready to work.
8. If the test fails - contact your system administrator.